ҚУЁШ ҲАВО КОЛЛЕКТОРЛАРИДА ТУРБУЛИЗАТОРЛАР ҚЎЛЛАНИЛГАНИДА ҲАВО ҲАРОРАТИ РЕЖИМИНИ КОМПЬЮТЕРЛИ МОДЕЛЛАШТИРИШ
Keywords:
solar collector, baffle-turbulator, collector efficiency, heat transfer, temperatureAbstract
This article proposes the installation of baffle-turbulator type intensifiers in flat solar air collectors. Theoretically investigated the temperature regime in the solar air collector when installing 2, 3, 4 and 8 baffle-turbulators. According to the results of the study, the average efficiency of a collector with 2, 3, 4 and 8 baffles-turbulators was 29,2%, 31,3%, 33,1 and 33,7%, respectively, in a simple collector – 28,9%.
References
Kalogirou S.A. (2004) Solar Thermal Collectors and Applications. Progress in Energy and Combustion Science, 30, 231-295. https://doi.org/ 10.1016/j.pecs.2004.02.001.
Zambolin E. and Del Col D. (2010) Experimental Analysis of Thermal Performance of Flat Plate and Evacuated Tube Solar Collectors in Stationary Standard and Daily Conditions. Solar Energy, 84, 1382-1396. https://doi.org/10.1016/j.solener.2010.04.020.
Aldabbagh L.B.Y., Egelioglu F. and Ilkan M. (2010) Single and Double Pass Solar Air Heaters with Wire Mesh as Packing Bed. Energy, 35, 3783-3787. https://doi.org/10.1016/j.energy.2010.05.028.
Velmurugan P. and Ramesh P. (2011) Evaluation of Thermal Performance of Wire Mesh Solar Air Heater. Indian Journal of Science and Technology, 4, 12-14.
Romdhane B.S. (2007) The Air Solar Collectors: Comparative Study, Introduction of Baffles to Favor the Heat Transfer. Solar Energy, 81, 139-149. https://doi.org/10.1016/j.solener.2006.05.002.
Pona, J. (1985) Increasing Thermal Efficiency of Solar Flat Plate Collectors. NASA STI/Recon Technical Report.
Abene A. (2004) Study of a Solar Air Flat Plate Collector: Use of Obstacles and Application for the Drying of Grape. Journal of Food Engineering, 65, 15-22. https://doi.org/10.1016/j.jfoodeng.2003.11.002.
Struckmann F. (2008) Analysis of Flat-Plate Solar Collector. Project Report, MVK160 Heat and Mass Transport, Lund.
Luna, D., Jannot, Y. and Nadeau, J.-P. (2010) An Oriented-Design Simplified Model for the Efficiency of a Flat Plate Solar Air Collector. Applied Thermal Engineering, 30, 2808-2814. https://doi.org/10.1016/j.applthermaleng. 2010.08.016.
Karatasou S., Santamouris M. and Geros V. (2006) On the Calculation of Solar Utilizability for South Oriented Flat Plate Collectors Tilted to an Angle Equal to the Local Latitude. Solar Energy, 80, 1600-1610. https://doi.org/10.1016/ j.solener.2005.12.003.
Uzakov G.N., Khamraev S.I., Khuzhakulov S.M. Rural house heat supply system based on solar energy // IOP Conf. Series: Materials Science and Engineering 1030 (2021) 012167 IOP Publishing doi:10.1088/1757-899X/1030/1/012167
